Parts involved in the procedure on your existing lock.
Danalock parts involved in the procedure.
1. Download the Danalock app
Go to Google Play or App Store and download the Danalock App.
When the app is installed you create a user profile by pressing the blue ring. You will use this profile each time you sign into the app.
You will need to finish setting the Danalock up in the app after mounting it on the door.
2. Get your tools together
To install the Danalock, you’ll need a Phillips screwdriver and tape, preferably masking tape.
Should you need to remove or readjust the lock, a pen tip or paper clip will be needed.
3. Check door alignment
Ensure that your door is properly aligned before beginning installation. You should be able to lock your door without pushing, pulling, or lifting the door.
4. Secure outside keyhole
Before removing your existing lock, use tape to secure the outside keyhole. This will keep it in place as you remove the screws on the inside.
5. Remove inside thumb-turn
Remove the inside thumb-turn, leaving just the deadbolt and tailpiece remaining. Set aside the screws. You’ll reinstall them in step 7.
6. Select a backplate
Find the backplate that matches the brand of your existing lock.
7. Remove the paper from the stickers
On the backside of the backplate you’ll find three stickers. Remove the paper from the stickers.
8. Fasten backplate
Fasten the backplate where the thumb-turn was using the two original screws, with the arrow on the label pointing up.
9. Select tailpiece adapter
Select the tailpiece adapter that matches the shape of your existing lock’s tailpiece.
10. Insert adapter into Danalock
Insert the selected tailpiece adapter into your Danalock and press until it clicks in place.
11. Fit and fasten Danalock
Fit the Danalock onto the backplate with the battery cover facing down, the tailpiece sliding into the adapter and the backplate notches into the back of the lock.
12. Align the platemarks
Find the small marking at the edge of the backplate and align it with the hole in the cover ring surrounding the Danalock.
Now you are sure to hit the notches on the backplate with the Danalock.
13. Fasten the Danalock
Turn the Danalock clockwise until it clicks to fasten it to the back plate.
NOTE: If you need to unfasten and retry, see “Uninstall instructions” at the end of the manual.
14. Activate batteries
Pull out the plastic tab to activate the batteries. A light will flash to confirm the Danalock is ready.
Note: If the batteries are disconnected, you will have to re-calibrate the Danalock.
15. Complete setup in the Danalock app
Your Danalock is now attached to the door. Download and open the Danalock app to finish setting it up.
Leave the door open, so the lock isn’t influenced when calibrated.
16. Configurate the Danalock
Open the Danalock app you downloaded at the start. When you have logged in you will see your empty keychain. Press ”Add lock” at the bottom of the screen.
A guide will now lead you through the installation and configuration of your Danalock.
17. Dismount instructions
If at any time you need to dismount the Danalock from your door, insert a pen tip into the hole at the top inner edge of the lock and press while turning the lock counter- clockwise until the lock releases.
This will not reset the lock or disconnect it from your account, but the lock may need to be re-calibrated if fastened to your door again.
